In this paper the design of a FIR filter with self checking capabilities based on the residue checking is analyzed. Usually the set of residues used to check the consistency of the results of the FIR filter are based of theoretic considerations about the dynamic range available with a chosen set of residues, the arithmetic characteristics of the errors caused by a fault and on the characteristic of the filter implementation. This analysis is often difficult to perform and, to obtain an acceptable fault coverage the set of chosen residues is overestimated. obtained result a and therefore requires that Instead, in this paper we show how using an exhaustive fault injection campaigns allows to efficiently select the best set of residues. Experimental results coming from fault injection campaigns on a 16 taps FIR filter demonstrated that by observing the occurred errors and the detection modules corresponding to different residue has been possible to reduce the number of detection module, while paying a small reduction of the percentage of SEUs that can be detected. © 2007 IEEE.
Pontarelli, S., Sterpone, L., Cardarilli, G.c., Re, M., Reorda, M.s., Salsano, A., et al. (2007). Optimization of self checking FIR filters by means of fault injection analysis. In Proceedings - IEEE International Symposium on Defect and Fault Tolerance in VLSI Systems (pp.96-102). 10662 LOS VAQUEROS CIRCLE, PO BOX 3014, LOS ALAMITOS, CA 90720-1264 USA : IEEE COMPUTER SOC [10.1109/DFT.2007.23].
Optimization of self checking FIR filters by means of fault injection analysis
Pontarelli S.;Cardarilli G. C.;Re M.;Salsano A.;
2007-01-01
Abstract
In this paper the design of a FIR filter with self checking capabilities based on the residue checking is analyzed. Usually the set of residues used to check the consistency of the results of the FIR filter are based of theoretic considerations about the dynamic range available with a chosen set of residues, the arithmetic characteristics of the errors caused by a fault and on the characteristic of the filter implementation. This analysis is often difficult to perform and, to obtain an acceptable fault coverage the set of chosen residues is overestimated. obtained result a and therefore requires that Instead, in this paper we show how using an exhaustive fault injection campaigns allows to efficiently select the best set of residues. Experimental results coming from fault injection campaigns on a 16 taps FIR filter demonstrated that by observing the occurred errors and the detection modules corresponding to different residue has been possible to reduce the number of detection module, while paying a small reduction of the percentage of SEUs that can be detected. © 2007 IEEE.I documenti in IRIS sono protetti da copyright e tutti i diritti sono riservati, salvo diversa indicazione.
